American Standard 4505SSF Installation Guide download pdf (Page 1)

SINGLE CONTROL

KITCHEN PULL-DOWN FAUCET

4505 Series

Thank you for selecting American-Standard...

the benchmark of ﬁne quality for over 100 years.

To ensure that your installation proceeds smoothly--

please read these instructions carefully before you begin.

Installation

Instructions

Certiﬁed to comply with ANSI A112.18.1M

INSTALL FAUCET WITH OR WITHOUT DECK ESCUTCHEON

PUTTY

SPOUT BASE

SINK OR

MOUNTING

SURFACE

SPOUT BASE

Assemble RUBBER WASHER (4), BRASS WASHER (5), and threaded LOCKNUT (6) onto SHANK (3) from underside

of sink or mounting surface. Hand tighten LOCKNUT (6).

Use a screwdriver to tighten SCREWS (8) on LOCKNUT (6). Work your way around LOCKNUT (6), tightening

the screws slightly each time until all are snug to ensure even pressure.

(A) Installation with ESCUTCHEON (1). Apply a bead of putty to bottom edge of ESCUTCHEON with PUTTY PLATE (1).

Insert SUPPLY HOSES (2), SPRAY HOSE (9) and SHANK (3) through hole of ESCUTCHEON with PUTTY PLATE (1) and

mounting surface. Follow mounting instructions below to secure faucet to mounting surface.

(B) Installation less ESCUTCHEON (1). Discard ESCUTCHEON with PUTTY PLATE (1). Insert supply HOSES (2), SPRAY

HOSE (9) and SHANK (3) through mounting hole and seat SPOUT BASE onto sink or mounting surface. Do not use putty.

Plumbers' Putty or Caulking

Adjustable Wrench

Phillips Screwdriver

RECOMMENDED TOOLS

Regular Screwdriver

9 9

Insert HOSES (2) through RUBBER WASHER (4), BRASS WASHER (5), and threaded LOCKNUT (6).

Turn off water at

main supply.

CAUTION

SYMPHONY

M965053

Make certain the SEAL (9) is properly seated in recess of spout base.

1 2 3

Summary of Contents

Page 1 - Instructions

SINGLE CONTROL KITCHEN PULL-DOWN FAUCET4505 SeriesThank you for selecting American-Standard...the benchmark of ﬁne quality for over 100 years.To ensur

Page 2 - 16"

CHECK CONNECTIONSFOR LEAKSCHECK CONNECTIONS FOR LEAKS.Move HANDLE down into "off" position.Turn on water supplies and check connections for

Page 3 - STREAM (AERATOR)

SERVICE6Clogged CARTRIDGE outlets or inlets may cause reduced ﬂow.To clean, ﬁrst turn off water supply then:75TEST INSTALLED FAUCETMove HANDLE (1) int