American Standard MONOBLOCK BIDET 2064.011 User Manual download pdf (Page 1)

M968851 Rev.1.3

Certiﬁed to comply with ANSI A112.18.1

Installation

Instructions

MONOBLOCK BIDET with

Speed Connect™ Drain

Adjustable Wrench Screwdriver Channel Locks

Recommended tools

Tubing Cutter

INSTALL FAUCET

Turn off hot and cold water

supplies before beginning.

CAUTION

2064.011

SERIN

™

GROOVE

(FAUCET

BASE)

MOUNTING

SURFACE

COLLAR ON

MOUNTING NUT

Seat SEAL (1) into under side of ESCUTCHEON RING (2).

Feed FAUCET SUPPLIES (3), MOUNTING STUD (4) and DRAIN

CABLE ASSEMBLY (8) through ESCUTCHEON RING (2) and the

mounting hole of lavatory or mounting surface. Figure A.

Seat ESCUTCHEON RING (2) with collar facing up into groove in

faucet base.

From below, push GASKET (7) and RETAINING WASHER (5) onto

MOUNTING STUD (4). Secure Faucet with MOUNTING NUT (6),

pulling faucet to front of sink, so SUPPLIES (3) rests against

mounting hole. Before ﬁnal tightening, make sure collar on

MOUNTING NUT (6) is seated into RETAINING WASHER (5).

Figure B.

Adjust Faucet so that it is centered. Tighten MOUNTING NUT (6)

to complete faucet mounting.

Figure A

Figure B

To ensure that your installation proceeds smoothly-please read these instructions carefully before you begin.

Congratulations on purchasing your American Standard

faucet with Speed Connect drain, a feature found only on

American Standard faucets.

*Your new American Standard faucet is designed to work only with the Speed Connect drain.

Speed Connect Drain*

• Fewer parts, installs in less time

• Never needs adjustment

• Guaranteed to seal properly the ﬁrst time, every time.

1 2 3 4 5 6

Summary of Contents

Page 1 - Instructions

M968851 Rev.1.3Certiﬁed to comply with ANSI A112.18.1InstallationInstructionsMONOBLOCK BIDET withSpeed Connect™ Drain Adjustable Wrench Screwdriver Ch

Page 2 - M968851 Rev.1.3

M968851 Rev.1.3POP-UP DRAINTighten TAILPIECE (4) on DRAIN BODY beforeinstalling DRAIN BODY. Fig. B.2432TIGHTEN LOCKNUT1REMOVE FLANGEThread FLANGE (1)

Page 3 - Fig. A. Fig. B

M968851 Rev.1.3Operate LIFT KNOB (1) to verify that STOPPER (2) opens andcloses.Note: If STOPPER (2) does not open and close properly then referto the

Page 4

124562.5mm HEX KEYREMOVE INSTALL378M968851 Rev.1.310TEST INSTALLED FITTINGWith HANDLE (1) in OFF position, turn on WATERSUPPLIES (2) and check all con

Page 5 - Speed Connect™ Drain

M968851 Rev.1.3Speed Connect™ DrainTroubleshooting GuideDisconnect the Cable from the Drain by threading the Cable Connector (1) counter-clockwise. Fi

Page 6

M968851 Rev.1.3STOPPER INSTALLATION PROCEDURELocked Mode: Look at the Plastic Loop at the bottom of the Stopper and noticethat the Loop is on one side