COLONY SOFT2175.503Turn off hot and cold watersupplies before beginning.CAUTION1Certified to comply with ANSI A112.18.1InstallationInstructionsSingle C
INSTALL POP-UP DRAININSTALL BLACK GASKET32Install BLACK CONE GASKET (1) onto DRAIN BODY (2)from below.Note: The flat side of the BLACK CONE GASKET (1)
Connect HOT water supply to inlet of left SHANK and COLDwater supply to right SHANK using sealant, appropriateconnectors, and COUPLING NUTS.Connect 1-
3CHECK DRAIN CONNECTIONS101112TEST INSTALLED FITTINGOperate POP-UP KNOB (5) and fill Sink with water. Checkthat DRAIN STOPPER (4) makes a good seal and
Speed Connect™ DrainTroubleshooting Guide12Disconnect the Cable from the Drain by threading the Cable Connector (1) counter-clockwise. Fig. A.Look at
STOPPER INSTALLATION PROCEDURELocked Mode: Look at the Plastic Loop at the bottom of the Stopper and noticethat the Loop is on one side of the Stopper
Comments to this Manuals