American Standard Elongated One-Piece Toilet 2003 User Manual download pdf

SAVE FOR FUTURE USE

730865-100 Rev. H

Product names listed herein are trademarks of American Standard Inc.

CAUTION: PRODUCT IS FRAGILE. TO AVOID BREAKAGE AND POSSIBLE INJURY HANDLE WITH CARE!

NOTE: Pictures may not exactly define contour of china and components.

Thank you for selecting American Standard - the benchmark of fine quality for over 100 years. To ensure this product is installed properly, please read

these instructions carefully before you begin. (Certain installations may require professional help.) Also be sure your installation conforms to local codes.

INSTALLATION INSTRUCTIONS

Champion

Model 2004 Normal Height Elongated One Piece Toilet

Model 2034 Right Height™ Elongated One Piece Toilet

RECOMMENDED TOOLS AND MATERIALS

Putty Knife

Closet Bolts

Regular Screwdriver

Wax Ring/Gasket

Adjustable Wrench

Flexible Supply Tube

Sealant

Hacksaw

Carpenters Level

Tape Measure

CLOSET

FLANGE

CLOSET

BOLTS

ROUGHING-IN DIMENSIONS:

NOTE: Distance from wall to closet flange centerline must be as listed below:

INSTALL WAX SEAL

Invert toilet on floor (cushion to prevent

damage), and install wax ring evenly

around waste flange (horn), with tapered

end of ring facing toilet. Apply a thin

bead of sealant around toilet base.

POSITION TOILET ON FLANGE

a. Unplug floor waste opening and install toilet on closet

flange so bolts project through mounting holes.

b. Loosely install retainer washers and nuts. Side of

washers marked "THIS SIDE UP" must face up!

4 53

WAX RING

SEALANT

Model 2004

29-3/4

(756mm)

(203mm)

1-3/4 (44mm)

1-1/4

(32mm)

(381mm)

13-1/2

(343mm)

10-3/4

(273mm)

28-1/8

(714mm)

16-3/4

(425mm)

17-3/4

(451mm)

FINISHED WALL

18-1/2

(470mm)

C/L OF SEAT

POST HOLES

5-1/2 (140mm)

CENTERS

(305mm)

1/2

(13mm)

10-3/4

(273mm)

4-1/2

(114mm)

SUPPLY

REQ'D

FINISHED

FLOOR

(178mm)

(102mm)

CLOSET

BOLT

NUT

TAPERED

WASHER

FLANGE

Recommended fitting type for back-to-back installations.

Depending upon your plumbing and venting conditions, the flow from

the Champion in a back-to-back installation may create a vacuum on

the system and draw water from the opposing bowl. The National

Standards Plumbing Code prohibits the use of a cross fitting for

drainage as throw over is possible. The code does approve a

directional "Y" style fitting with proper venting to direct the water

downward and away from the other toilet.

NOTE: BACK-TO-BACK INSTALLATION

REMOVE OLD TOILET

a. Close toilet supply valve and flush tank completely. Towel or sponge remaining water from tank and bowl.

b. Disconnect and remove supply line. NOTE: If replacing valve, first shut off main water supply!

c. Remove old mounting hardware, remove toilet and plug floor waste opening to prevent escaping sewer gases.

d. Remove closet bolts from flange and clean away old wax, putty, etc. from base area.

NOTE: Mounting surface must be clean and level before new toilet is installed!

Model 2034

29-3/4

(756mm)

(203mm)

1-3/4 (44mm)

1-1/4

(32mm)

16-1/2

(419mm)

13-1/2

(343mm)

10-3/4

(273mm)

29-1/2

(749mm)

16-3/4

(425mm)

17-3/4

(451mm)

FINISHED WALL

(25mm)

18-1/2

(470mm)

C/L OF SEAT

POST HOLES

5-1/2 (140mm)

CENTERS

(305mm)

C/L OF OUTLETC/L OF OUTLET

1/2

(13mm)

10-3/4

(273mm)

4-1/2

(114mm)

SUPPLY

REQ'D

FINISHED

FLOOR

(178mm)

3-3/4

(95mm)

INSTALL CLOSET BOLTS

Install closet bolts in flange

channel, turn 90°, and slide into

place 6" (152mm) apart and

parallel to wall.

1 2 3 4

Summary of Contents

Page 1 - Champion

SAVE FOR FUTURE USE730865-100 Rev. HProduct names listed herein are trademarks of American Standard Inc.© American Standard Inc. 2007CAUTION: PRODUCT

Page 2 - DO NOT OVERTIGHTEN

730865-100 Rev. H- 2 -INSTALL TOILETa. Position toilet squarely to wall and, with a rocking motion, press bowl down fully on wax ring and flange.

Page 3 - San Juan Capistrano, CA 92675

730865-100 Rev. H- 3 -• Make sure water supply is off. Remove valve TOP by lifting arm and rotating top and arm 1/8 turn counterclockwise, pressing do

Page 4 - REPAIR PARTS LIST

730865-100 Rev. H- 4 -Does not flushPoor or sluggish flushToilet leaksToilet does not shut offa. Water supply valve closed.b. Supply line blocked.c.

Comments to this Manuals

No comments

American Standard Elongated One-Piece Toilet 2003 User Manual

Browse online or download User Manual for Sanitary ware American Standard Elongated One-Piece Toilet 2003. American Standard Elongated One-Piece Toilet 2003 User's Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Sanitary ware American Standard Elongated One-Piece Toilet 2003