American Standard 2275503.002 Installation Guide download pdf (Page 1)

COLONY SOFT

2275.403

2275.503

Insert FAUCET (1) and CABLE CONNECTOR (2) through center hole

of mounting surface. Fig. A.

From under side of mounting surface thread the two MOUNTING

NUTS (3) onto FAUCET SHANKS (4). Fig. B.

Center FAUCET (1) and hand tighten MOUNTING NUTS (3) to

secure FAUCET (1).

Certiﬁed to comply with ANSI A112.18.1

Installation

Instructions

Centerset Lavatory Faucet

with Speed Connect™ Drain

INSTALL FAUCET

Adjustable Wrench Screwdriver Channel Locks

Recommended tools

Tubing Cutter

Congratulations on purchasing your American Standard faucet

with the Speed Connect drain, a features found only on

American Standard faucets.

Speed Connect Drain*

• 1/3 of the parts, installs in 1/3 of the time

• No tools needed

• Never needs adjustment

• Guaranteed to seal properly the ﬁrst time, every time.

*Your new American Standard faucet is designed to work only with the Speed Connect drain.

To ensure that your installation proceeds smoothly-please read these instructions carefully

before you begin.

Fig. A.

Fig. B.

M968877 Rev. 1.2

Plumbers' Putty or Caulking

(HAND TIGHTEN)

Apply a bead of putty along the edge of the underside of the FAUCET (1).

PUTTY

Turn off water at

main supply.

CAUTION

1 2 3 4 5 6

Summary of Contents

Page 1 - Instructions

COLONY SOFT2275.4032275.503Insert FAUCET (1) and CABLE CONNECTOR (2) through center holeof mounting surface. Fig. A.From under side of mounting surfac

Page 2 - POP-UP KNOB

INSTALL POP-UP DRAININSTALL BLACK GASKET32Install BLACK CONE GASKET (1) onto DRAIN BODY (2)from below.Note: The ﬂat side of the BLACK CONE GASKET (1)

Page 3 - CHECK OPERATION OF POP-UP

Connect HOT water supply to inlet of left SHANK and COLDwater supply to right SHANK using sealant, appropriateconnectors, and COUPLING NUTS.Connect 1-

Page 4

3CHECK DRAIN CONNECTIONS1012TEST INSTALLED FITTINGOperate POP-UP KNOB (5) and ﬁll Sink with water. Checkthat DRAIN STOPPER (4) makes a good seal and r

Page 5 - Speed Connect™ Drain

Speed Connect™ DrainTroubleshooting Guide12Disconnect the Cable from the Drain by threading the Cable Connector (1) counter-clockwise. Fig. A.Look at

Page 6 - M968877 Rev. 1.2

STOPPER INSTALLATION PROCEDURELocked Mode: Look at the Plastic Loop at the bottom of the Stopper and noticethat the Loop is on one side of the Stopper