American Standard 2742.XXXW User Manual download pdf (Page 2)

753027-100 REV. E

(2)

UNLESS AN ACCESS OPENING OF

AT LEAST 12" X 24" (305 X 610MM)

IS PROVIDED, WARRANTY SERVICE

WILL NOT BE PERFORMED.

LEVELING

SURFACE

WATERPROOF

SEALANT

BATH

TYPICAL PIER TYPE INSTALLATION

AS DESIRED

1022mm

(40-1/4)

AS

DESIRED

1778mm

(70)

CUTOUT

508mm

(20)

ACCESS PANEL

610mm

(24)

305mm

(12)

INSTALLATION AND FRAMING INSTRUCTIONS

The variety of installations possible for this whirlpool may require framing procedures other than those shown. Locate studs

as required. Ensure roughing-in dimensions are proper, plumb and square. Provisions must be made in all installations for an

access opening for servicing the pump and controls. It is strongly recommended that an additional opening be provided for

access to the drain components.

1. Position the whirlpool into the installation opening and level the deck, shimming the integral support feet as necessary.

2. Install drain components to the whirlpool following the manufacturers instructions. Before replacing your whirlpool for ﬁnal

installation, be certain that an opening has been provided in the sub-ﬂoor for the drain. See the roughing-in drawing for

suggested opening size and location dimensions.

3. Replace whirlpool and re-shim the integral support feet, shimming the entire length of the support feet. Secure the shims

using construction adhesive, silicone, mortar or equivalent materials. While not a necessity, the use of a foundation base

consisting of cement (e.g. Sakrete), mortar, or grout will help provide a solid and secure installation.

1 2 3 4

Comments to this Manuals

No comments